Toyota ECU Flasher Read/Write NEC 7F00XX Flash Memory

Toyota ECU Flasher is a multipurpose ECU programmer for Denso and Fujitsu Ten ECUs with NEC processors,which installed in TOYOTA, LEXUS and SCION vehicles with petrol and diesel engines through JTAG interface.

 ‌Without any doubt‌,Toyota Flasher (v1.16) is a unique solution in the chip tuning world. The Flasher can read, flash, clear, verificate internal flash memory of microcontrollers if connected to the appropriate connector on the ECU circuit board.Not only JTAG but also OBD writing via CAN bus is supported.

Notices:

•  ‌In fact This is clone ones manufactured by ECUHELP,not original Device .
• DO NOT USE external 12V power if connect to car OBD connector!!!use USB powering ONLY !!!
• work offline mode,certainly Never Update it !!

Supported DENSO ECUs with NEC 7F00XX:

• 76F0038, 76F0038A,
• 76F0039, 76F0039A,
• 76F0040, 76F0040A,
• 76F0070 BGA,
• 76F0085 BGA.

Year Coverage :

1. SUPPORT 2015 + OBD WRITE
2. SOME MODELS 2015 + by OBD READ
3. GEN_2 CAN-BUS RECOVERY MODE

Toyota ECU Flasher Advantages:

• Its own hardware interface allows to avoid all compatibility and driver problems;
• Work through built-in 20 or 26 pin JTAG connector;
• Full access to the ECU memory.Moreover‌,working at high speed of more than 100 KB/s;
• Saving files in the open format;
• Firmware checksum verification and recalculation.

Package List:

• Toyota Flasher Host
• OBDII cable
• BDM Cable
• Mitsubshi boot adapter
• 12V/3A power adapter
• USB A to B cable
• adapter
• pins